'

Search results

Found 1097 matches
Shear stress (acting on the bed of a channel)

For a channel that is at an angle a from horizontal, the shear component of the stress acting on the bed , which is the component acting ... more

Worksheet 302

In the wheelbarrow of the following figure the load has a perpendicular lever arm of 7.50 cm, while the hands have a perpendicular lever arm of 1.02 m.(a) What upward force must you exert to support the wheelbarrow and its load if their combined mass is 45.0 kg? (b) What force does the wheelbarrow exert on the ground?


(a) In the case of the wheelbarrow, the output force or load is between the pivot and the input force. The pivot is the wheel’s axle. Here, the output force is greater than the input force. Thus, a wheelbarrow enables you to lift much heavier loads than you could with your body alone. (b) In the case of the shovel, the input force is between the pivot and the load, but the input lever arm is shorter than the output lever arm. The pivot is at the handle held by the right hand. Here, the output force (supporting the shovel’s load) is less than the input force (from the hand nearest the load), because the input is exerted closer to the pivot than is the output.

Strategy

Here, we use the concept of mechanical advantage.

Force (Newton's second law)
Mechanical Advantage - Law of Lever
Subtraction

Discussion
An even longer handle would reduce the force needed to lift the load. The MA here is:

Division

Reference : OpenStax College,College Physics. OpenStax College. 21 June 2012.
http://openstaxcollege.org/textbooks/college-physics
Creative Commons License : http://creativecommons.org/licenses/by/3.0/

Arbitrary-amplitude period of pendulum

A pendulum is a body suspended from a fixed support so that it swings freely back and forth under the influence of gravity. A so-called “simple ... more

Gaussian beam (Beam width or spot size)

In optics, a Gaussian beam is a beam of electromagnetic radiation whose transverse electric field and intensity (irradiance) distributions are well ... more

Center of mass (for two particles)

The center of mass of a distribution of mass in space is the unique point where the weighted relative position of the distributed mass sums to zero.
... more

Backlash (due to operating center modifications)

In mechanical engineering, backlash, sometimes called lash or play, is clearance or lost motion in a mechanism caused by gaps between the parts. It can be ... more

Accident modification factor

The safety of a horizontal curve is affected by the length of the curve, the curve radius, whether spiral transition curves are used, and the ... more

Vertical Parabola (Standard Equation)

Parabola is a two-dimensional, mirror-symmetrical curve, which is approximately U-shaped but which can be in any orientation in its plane. A parabola is ... more

Radius of the circumcircle of a triangle

The radius of the circle on which lie a set of points is, by definition, the radius of the circumcircle of any triangle with vertices at any three of those ... more

Rhombus' side

The length of the side can computed by the length of the diagonals

... more

...can't find what you're looking for?

Create a new formula