'

Search results

Found 1201 matches
Rolling Resistance Coefficient - alternative

As an alternative to using Crr one can use b, which is a different rolling resistance coefficient or coefficient of rolling friction with dimension of ... more

Total constant power (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

Cycloid (Cartesian equation)

A cycloid is the curve traced by a point on the rim of a circular wheel as the wheel rolls along a straight line without slippage. It is an example of a ... more

Turbine specific speed

The specific speed value (radian/second) for a turbine is the speed of a geometrically similar turbine which would produce one unit of the specific speed ... more

Radius of the turn of an upright bike (for small steering angles)

In order for a bike to turn, that is, change its direction of forward travel, the front wheel must aim approximately in the desired direction, as with any ... more

Cycloid ( parametric equation Y-coordinate)

A cycloid is the curve traced by a point on the rim of a circular wheel as the wheel rolls along a straight line without slippage. It is an example of a ... more

Cycloid ( parametric equation X- coordinate)

A cycloid is the curve traced by a point on the rim of a circular wheel as the wheel rolls along a straight line without slippage. It is an example of a ... more

Total constant power (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

Damping ratio (related to Quality factor)

Formula first contributed by:
trooper

In engineering, the damping ratio is a dimensionless measure describing how ... more

Leaning ( for bikes and motorcycles)

Bikes must lean during a turn to balance the relevant forces: gravitational, inertial, frictional, and ground support. The angle of lean can be ... more

...can't find what you're looking for?

Create a new formula