'

Search results

Found 1013 matches
Bivariate (two variable) quadratic function(x minimum/maximum)

A bivariate (two variable) quadratic function is a second-degree polynomial which describes a quadratic surface and has the form: f(x,y)=Ax^2 + By^2 + ... more

Compound lens' focal length (separated in air by some distance )

A lens is a transmissive optical device which affects the focusing of a light beam through refraction. A simple lens consists of a single piece of ... more

Gay-Lussac's Law (Pressure-temperature law)

The pressure of a gas of fixed mass and fixed volume is directly proportional to the gas’ absolute temperature. If a gas’s temperature ... more

Specific Impulse

Specific impulse (usually abbreviated Isp) is a way to describe the efficiency of rocket and jet engines. It represents the force with respect to the ... more

Linear charge density

Linear density is the measure of a quantity of any characteristic value per unit of length. Llinear charge density (the amount of electric charge per unit ... more

Linear equation( Point–slope form)

A linear equation is an algebraic equation in which each term is either a constant or the product of a constant and (the first power of) a single variable. ... more

Archimedean spiral

The Archimedean spiral is the locus of points corresponding to the locations over time of a point moving away from a fixed point with a constant speed ... more

Margin of safety for a failure load (measure of structural capacity)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

Engine displacement

Engine displacement is the volume swept by all the pistons inside the cylinders of a reciprocating engine in a single movement from top dead centre (... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

...can't find what you're looking for?

Create a new formula