'

Search results

Found 890 matches
Tensile force for non-undercut threaded rod

A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the ... more

Simplified von Mises equation - Pure shear

RESTRICTIONS : σ₁ = σ₂ = σ₃ = 0, σ₃₁ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials ... more

Ball Screw - Preload Drag Torque

A ball screw is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical ... more

Johnson-Kendall-Roberts (JKR) model of elastic contact between two spheres ( pull-off force)

Contact mechanics is the study of the deformation of solids that touch each other at one or more points.When two solid surfaces are brought into close ... more

Maugis-Dugdale model of elastic contact between two spheres (depth of penetration)

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more

Simplified von Mises equation - Principal plane stress

RESTRICTIONS : σ₃ = 0, σ₁₂ = σ₁₃ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials begins ... more

Turnbuckle (The direct shear stress induced in screw thread)

A mechanical joint is a part of a machine which is used to connect another mechanical part or mechanism. Mechanical joints may be temporary or permanent. ... more

Effective Radius of a Contact Area between two spheres

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more

Peukert's law

Peukert’s law, presented by the German scientist Wilhelm Peukert in 1897, expresses the capacity of a battery in terms of the rate at which it is ... more

Backlash (due to operating center modifications)

In mechanical engineering, backlash, sometimes called lash or play, is clearance or lost motion in a mechanism caused by gaps between the parts. It can be ... more

...can't find what you're looking for?

Create a new formula