'

Search results

Found 890 matches
Knoop hardness test

The Knoop hardness test /kəˈnuːp/ is a microhardness test – a test for mechanical hardness used particularly for very brittle materials or thin sheets, ... more

Cantilever Euler Beam - Maximum Displacement

Euler–Bernoulli beam theory (also known as engineer’s beam theory or classical beam theory) is a simplification of the linear theory of elasticity ... more

Allowable bearing capacity

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Weight transfer ( or load transfer)

In the automobile industry, weight transfer customarily refers to the change in load borne by different wheels during acceleration and the change in ... more

Barlow's formula - pipe

In the pipeline industry it is neccecary to verify that pipe used for gathering, transmission, and distribution lines can safely withstand operating ... more

Knuckle joint (Moment about axis XX)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

Brake clamp load

The clamping load is assumed to act on all friction surfaces equally. For dry disc brakes it doesn’t matter whether the brake is of the sliding type or ... more

Critical Buckling Stress of a Column with Buckling Coefficient

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Brinell scale ( using the SI units)

The Brinell scale characterizes the indentation hardness of materials through the scale of penetration of an indenter, loaded on a material test-piece. It ... more

Total constant power (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

...can't find what you're looking for?

Create a new formula