'

Search results

Found 1690 matches
Mass Ratio - Rockets

In aerospace engineering, mass ratio is a measure of the efficiency of a rocket. It describes how much more massive the vehicle is with propellant than ... more

Trip distribution zonal interchange model (related to trip origins and destinations)

Trip distribution (or destination choice or zonal interchange analysis) is the second component (after trip generation, but before mode choice and route ... more

Acceleration

Acceleration, in physics, is the rate at which the velocity of an object changes over time. Mathematically, instantaneous acceleration—acceleration over an ... more

Lorentz Factor

The Lorentz factor or Lorentz term is an expression which appears in several equations in special relativity. It arises from deriving the Lorentz ... more

Batchelor vortex (core size)

In fluid dynamics, Batchelor vortices have been found useful in analyses of airplane vortex wake hazard problems. The Batchelor vortex is an approximate ... more

Cardioid ( X-coordinate)

A cardioid is a plane curve traced by a point on the perimeter of a circle that is rolling around a fixed circle of the same radius. It is therefore a type ... more

Cardioid ( Y-coordinate)

A cardioid is a plane curve traced by a point on the perimeter of a circle that is rolling around a fixed circle of the same radius. It is therefore a type ... more

Entropy analysis - Trip distribution (proportional to trip origins and destinations)

Trip distribution (or destination choice or zonal interchange analysis) is the second component (after trip generation, but before mode choice and route ... more

Vertical Curve - Stopping Sight Distance

Sight distance is dependent on the type of curve used and the design speed. For crest curves, sight distance is limited by the curve itself, as the curve ... more

Nq bearing capacity factor

Karl von Terzaghi was the first to present a comprehensive theory for the evaluation of the ultimate bearing capacity of rough shallow foundations. This ... more

...can't find what you're looking for?

Create a new formula