Search results
The clamping load is assumed to act on all friction surfaces equally. For dry disc brakes it doesn’t matter whether the brake is of the sliding type or ... more
In engineering, deflection is the degree to which a structural element is displaced under a load.
The maximum elastic deflection on a beam supported
... more
A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more
In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more
Elastic deflection is the degree to which a structural element is displaced under a load.
The deflection at any point, along the span of a center
... more
In engineering, deflection is the degree to which a structural element is displaced under a load.
This maximum deflection occurs at a distance x_1
... more
In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more
In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more
A ball screw is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical ... more
In the design of fluid bearings, the Sommerfeld number (S), or bearing characteristic number, is a dimensionless quantity used extensively in hydrodynamic ... more
...can't find what you're looking for?
Create a new formula