'

Search results

Found 1082 matches
Q factor for a series resonant circuit (RL circuits)

It is defined as the peak energy stored in the circuit divided by the average energy dissipated in it per cycle at resonance; Q factor is directly ... more

Fractional bandwidth (RLC circuits)

The bandwidth as a fraction of the resonance frequency. Bandwidth is the difference between the upper and lower frequencies in a continuous set of ... more

Damping factor (RLC circuit)

Damping is an influence within or upon an oscillatory system that has the effect of reducing, restricting or preventing its oscillations.( The neper ... more

Cyclotron resonance frequency

A cyclotron is a type of particle accelerator in which charged particles accelerate outwards from the center along a spiral path. The particles are held to ... more

Time Constant in RC electrical circuits

In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more

Time Constant in RL electrical circuits

In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more

Time Constant in digital electronic circuits

In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more

Percentage overshoot (PO)

In signal processing, control theory, electronics, and mathematics, overshoot is the occurrence of a signal or function exceeding its target. It arises ... more

Rotary variable differential transformer(RVDT) - Rotor mechanical angle

A rotary variable differential transformer (RVDT) is a type of electrical transformer used for measuring angular ... more

Flywheel (hoop stress on the rotor)

A flywheel is a rotating mechanical device that is used to store rotational energy. Flywheels have a significant moment of inertia and thus resist changes ... more

...can't find what you're looking for?

Create a new formula