'

Search results

Found 1899 matches
Thrust-to-Weight Ratio - Propeller-driven aircraft

Thrust-to-weight ratio (TWR) is a dimensionless ratio of thrust to weight of a rocket, jet engine, propeller engine, or a vehicle ... more

Inductors in Series

Components of an electrical circuit or electronic circuit can be connected in many different ways. The two simplest of these are called series and parallel ... more

Relation between the inradius and exradii of a right triangle

Right triangle or right-angled triangle is a triangle in which one angle is a right angle (that is, a 90-degree angle). The incircle or inscribed circle of ... more

Inductors in Parallel

Components of an electrical circuit or electronic circuit can be connected in many different ways. The two simplest of these are called series and parallel ... more

Clairaut's theorem

Clairaut’s theorem is a general mathematical law applying to spheroids of revolution. The formula can be used to relate the gravity at any point on ... more

Moment of inertia of a thick-walled cylindrical tube ( Axis at the center of the cylinder perpendicular to its height)

Moment of inertia is the mass property of a rigid body that defines the torque needed for a desired angular acceleration about an axis of rotation. Moment ... more

Wet bulk density of soil (total bulk density)

Bulk density is a property of powders, granules, and other “divided” solids, especially used in reference to mineral components (soil, gravel), ... more

Lean angle due to a tire thickness of a bicycle

The finite width of the tires alters the actual lean angle of the rear frame from the ideal lean angle described above. The actual lean angle between the ... more

Critical buckling stress of a column

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

...can't find what you're looking for?

Create a new formula