'

Search results

Found 1717 matches
Klein bagel (4-D non-intersecting parameterization y- coordinate)

n mathematics, the Klein bottle is an example of a non-orientable surface, informally, it is a surface (a two-dimensional manifold) in which notions of ... more

Elastic deflection at any point along the span of a center loaded beam

Elastic deflection is the degree to which a structural element is displaced under a load.
The deflection at any point, along the span of a center ... more

Margin of safety (measure of requirement verification)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

Total constant power (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

Klein bagel (4-D non-intersecting parameterization x- coordinate)

n mathematics, the Klein bottle is an example of a non-orientable surface, informally, it is a surface (a two-dimensional manifold) in which notions of ... more

Tangential quadrilateral ( the sum of the opposite sides)

In Euclidean geometry, a tangential quadrilateral (sometimes just tangent quadrilateral) or circumscribed quadrilateral is a convex quadrilateral whose ... more

Auger electron spectroscopy - Energetics of Auger transitions (more rigorous model)

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Maximum elastic deflection of an off-center loaded beam supported by two simple supports

In engineering, deflection is the degree to which a structural element is displaced under a load.
The maximum elastic deflection on a beam supported ... more

Capital market line (CML)

Capital market line (CML) is the tangent line drawn from the point of the risk-free asset to the feasible region for risky ... more

Speeds and feeds - Spindle speed

The phrase speeds and feeds or feeds and speeds refers to two separate velocities in machine tool practice, cutting speed and feed rate. They are often ... more

...can't find what you're looking for?

Create a new formula