'

Search results

Found 1480 matches
Second moment of area - I-Beam (W-section)

An I-beam, also known as H-beam, W-beam (for “wide flange”), Universal Beam (UB), Rolled Steel Joist (RSJ), or ... more

Force due to water hammer (Slow valve closure)

Water hammer (or, more generally, fluid hammer) is a pressure surge or wave caused when a fluid (usually a liquid but sometimes also a gas) in motion is ... more

Simplified von Mises equation - Pure shear

RESTRICTIONS : σ₁ = σ₂ = σ₃ = 0, σ₃₁ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials ... more

Brushed DC electric motor - Speed

A brushed DC motor is an internally commutated electric motor designed to be run from a direct current power source. Brushed motors were the first ... more

Hydraulic pump flow

A hydraulic pump is a mechanical sourse of power that converts mechanical power into hydraulic energy (hydrostatic energy i.e. flow, pressure). It ... more

Worksheet 302

In the wheelbarrow of the following figure the load has a perpendicular lever arm of 7.50 cm, while the hands have a perpendicular lever arm of 1.02 m.(a) What upward force must you exert to support the wheelbarrow and its load if their combined mass is 45.0 kg? (b) What force does the wheelbarrow exert on the ground?


(a) In the case of the wheelbarrow, the output force or load is between the pivot and the input force. The pivot is the wheel’s axle. Here, the output force is greater than the input force. Thus, a wheelbarrow enables you to lift much heavier loads than you could with your body alone. (b) In the case of the shovel, the input force is between the pivot and the load, but the input lever arm is shorter than the output lever arm. The pivot is at the handle held by the right hand. Here, the output force (supporting the shovel’s load) is less than the input force (from the hand nearest the load), because the input is exerted closer to the pivot than is the output.

Strategy

Here, we use the concept of mechanical advantage.

Force (Newton's second law)
Mechanical Advantage - Law of Lever
Subtraction

Discussion
An even longer handle would reduce the force needed to lift the load. The MA here is:

Division

Reference : OpenStax College,College Physics. OpenStax College. 21 June 2012.
http://openstaxcollege.org/textbooks/college-physics
Creative Commons License : http://creativecommons.org/licenses/by/3.0/

Screw - torque

A screw is a mechanism that converts rotational motion to linear motion, and a torque (rotational force) to a linear force. It is one of the six classical ... more

Potentiometer Voltage Divider

Potentiometer is a three-terminal resistor with a sliding contact that forms an adjustable voltage divider. The potentiometer can be used as a voltage ... more

Plateau–Rayleigh instability

The Plateau–Rayleigh instability, often just called the Rayleigh instability, explains why and how a falling stream of fluid breaks up into smaller packets ... more

Vapor Pressure

Vapor pressure or equilibrium vapor pressure is defined as the pressure exerted by a vapor in thermodynamic equilibrium with its condensed phases (solid or ... more

...can't find what you're looking for?

Create a new formula