'

Search results

Found 536 matches
Spring constant

Hooke’s law is a principle of physics that states that the force F needed to extend or compress a spring by some distance X is proportional to that ... more

Margin of safety for a failure load (measure of structural capacity)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

K2 for Danish-Kumar Solution

A Bingham plastic is a viscoplastic material that behaves as a rigid body at low stresses but flows as a viscous fluid at high stress. It is named after ... more

Present value of a perpetuity (Present Value of Int Factor Annuity)

A perpetuity is payments of a set amount of money that occur on a routine basis and continues forever. Present value of a perpetuity is an infinite and ... more

K1 for Danish-Kumar Solution

A Bingham plastic is a viscoplastic material that behaves as a rigid body at low stresses but flows as a viscous fluid at high stress. It is named after ... more

Kepler's Second Law

In astronomy, Kepler’s laws of planetary motion are three scientific laws describing the motion of planets around the Sun.

1.The orbit of a ... more

Distance of L3 Langarian point

In celestial mechanics, the Lagrangian points (also Lagrange points, L-points, or libration points) are positions in an orbital configuration of two large ... more

Distance of L1 and L2 Langarian points(M2<<M1)

In celestial mechanics, the Lagrangian points (also Lagrange points, L-points, or libration points) are positions in an orbital configuration of two large ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq2)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Reduced specific volume

In thermodynamicsIn thermodynamics, the reduced properties of a fluid are a set of state variables normalized by the fluid’s state properties at its ... more

...can't find what you're looking for?

Create a new formula