'

Search results

Found 807 matches
Graveyard Orbit - Minimum Perigee Altitude

A graveyard orbit, also called a junk orbit or disposal orbit, is a supersynchronous orbit that lies significantly above synchronous orbit, where ... more

Αxial stiffness for an element in tension

The stiffness of a body is a measure of the resistance offered by an elastic body to deformation.
Tension describes the pulling force exerted by each ... more

Shear rate at the inner wall of a Newtonian fluid (flowing within a pipe)

A Newtonian fluid is a fluid in which the viscous stresses arising from its flow, at every point, are proportional to the local strain rate — the rate of ... more

Cylinder stress (axial stress)

A pressure vessel is a closed container designed to hold gases or liquids at a pressure substantially different from the ambient pressure.
When a ... more

Critical Buckling Compressive Loading of a Plate

In science, buckling is a mathematical instability that leads to a failure mode.

When a structure is subjected to compressive stress, buckling may ... more

Metcalfe’s Law

Metcalfe’s law states that the value of a telecommunications network is proportional to the square of the number of connected users of the system ... more

Margin of safety (measure of structural capacity)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

Excess pressure due to water hammer

Water hammer (or, more generally, fluid hammer) is a pressure surge or wave caused when a fluid (usually a liquid but sometimes also a gas) in motion is ... more

Gravitational Potential (spherical symmetry)

Within a uniform spherical body of radius R and density ρ the gravitational force g inside the sphere varies linearly with distance r from the center, ... more

Flux (as a single scalar)

Flux is two separate simple and ubiquitous concepts throughout physics and applied mathematics. Within a discipline, the term is generally used ... more

...can't find what you're looking for?

Create a new formula