'

Search results

Found 1611 matches
Current gain

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input ... more

Power gain

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input ... more

Voltage gain

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input ... more

Terrestrial Time

Terrestrial Time (TT) is a modern astronomical time standard defined by the International Astronomical Union, primarily for time-measurements of ... more

Radiant Exitance (real surface)

In radiometry, radiant exitance is the radiant flux emitted by a surface per unit area, and spectral exitance is the radiant exitance of a surface per unit ... more

Fluid Thread Breakup - Linear Stability of Inviscid Liquids

Fluid thread breakup is the process by which a single mass of fluid breaks into several smaller fluid masses. The process is characterized by the ... more

Poisson Distribution

In probability theory and statistics, the Poisson distribution (French pronunciation [pwasɔ̃]; in English usually /ˈpwɑːsɒn/), named after French ... more

Worksheet 341

The awe‐inspiring Great Pyramid of Cheops was built more than 4500 years ago. Its square base, originally 230 m on a side, covered 13.1 acres, and it was 146 m high (H), with a mass of about 7×10^9 kg. (The pyramid’s dimensions are slightly different today due to quarrying and some sagging). Historians estimate that 20,000 workers spent 20 years to construct it, working 12-hour days, 330 days per year.

a) Calculate the gravitational potential energy stored in the pyramid, given its center of mass is at one-fourth its height.

Division
Potential energy

b) Only a fraction of the workers lifted blocks; most were involved in support services such as building ramps, bringing food and water, and hauling blocks to the site. Calculate the efficiency of the workers who did the lifting, assuming there were 1000 of them and they consumed food energy at the rate of 300 Kcal/hour.

first we calculate the number of hours worked per year.

Multiplication

then we calculate the number of hours worked in the 20 years.

Multiplication

Then we calculate the energy consumed in 20 years knowing the energy consumed per hour and the total hours worked in 20 years.

Multiplication
Multiplication

The efficiency is the resulting potential energy divided by the consumed energy.

Division
Half-Life

Half-life is the amount of time required for the amount of something to fall to half its initial value. The term is very commonly used in nuclear physics ... more

True anomaly

In astronomy, Kepler’s laws of planetary motion are three scientific laws describing the motion of planets around the Sun.

1- The orbit of ... more

...can't find what you're looking for?

Create a new formula