# Search results

Found 1077 matches
Monatomic ideal gas heat capacity at constant pressure

Heat capacity or thermal capacity is a physical quantity equal to the ratio of the heat that is added to (or removed from) an object to the resulting ... more

Freezing point depression (cryoscopy)

Colligative properties are properties of solutions that depend upon the ratio of the number of solute particles to the number of solvent molecules in a ... more

Creep (deformation)

In materials science, creep (sometimes called cold flow) is the tendency of a solid material to move slowly or deform permanently under the influence of ... more

The equation for the desired radius of a curve, takes into account the factors of speed and superelevation (e). This equation can be algebraically ... more

A ball screw is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical ... more

Darcy friction factor - Serghides's solution (Variable B)

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Darcy friction factor - Goudarâ€“Sonnad equation (Variable g)

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Darcy friction factor - Serghides's solution (Variable C)

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Solar cell - current delivered by the illuminated diode

Operation of a solar cell can be understood from the equivalent circuit at right. Light, of sufficient energy (greater than the bandgap of the material), ... more

Beale number

In mechanical engineering, the Beale number is a parameter that characterizes the performance of Stirling engines. It is often used to estimate the power ... more

...can't find what you're looking for?

Create a new formula