'

Search results

Found 1065 matches
Rouse Number

The Rouse number (P or Z) is a non-dimensional number in fluid dynamics which is used to define a concentration profile of suspended sediment and which ... more

Maximum elastic deflection of an off-center loaded beam supported by two simple supports

In engineering, deflection is the degree to which a structural element is displaced under a load.
The maximum elastic deflection on a beam supported ... more

Vertical Wind Profile - Power Law

The design of buildings must account for wind loads, and these are affected by wind shear. For engineering purposes, a power law wind speed profile may be ... more

Boundary shear stress (for natural rivers)

Assuming a single, well-mixed, homogeneous fluid and a single acceleration due to gravity (both are good assumptions in natural rivers, and the second is a ... more

Shear resistance of a pin

This formula calculates the shear resistance of a pin in a pin and plate connection.
From EN 1993-1-8 (2005) (English): Eurocode 3: Design of steel ... more

Angle of deflection of an end loaded cantilever beam

In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of ... more

Angle of deflection of a uniformly loaded cantilever beam

In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of ... more

Tuning fork (cylindrical prongs)

A tuning fork is an acoustic resonator in the form of a two-pronged fork with the prongs (tines) formed from a U-shaped bar of elastic metal (usually ... more

Angular resolution

Angular resolution or spatial resolution describes the ability of any image-forming device such as an optical or radio telescope, a microscope, a camera, ... more

Tensile Stress Area

Bolted joints are one of the most common elements in construction and machine design. They consist of fasteners that capture and join other parts, and are ... more

...can't find what you're looking for?

Create a new formula