'

Search results

Found 920 matches
Beale number

In mechanical engineering, the Beale number is a parameter that characterizes the performance of Stirling engines. It is often used to estimate the power ... more

Coefficient D(T,P) - used in UNESCO equation

The coefficient D(T,P) used in the UNESCO equation, speed of sound in sea water), depends on the temperature and the pressure

... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq6a)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq6b)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Shape Factor (Boundary-layer thickness)

A shape factor is used in boundary layer flow to determine the nature of the flow.
The higher the value of H, the stronger the adverse pressure ... more

Evaporation - Penman Equation (Shuttleworth modification)

The Penman equation describes evaporation (E) from an open water surface, and was developed by Howard Penman in 1948. Penman’s equation requires ... more

Slip factor

In turbomachinery, the slip factor is a measure of the fluid slip in the impeller of a compressor or a turbine, mostly a centrifugal machine. Fluid slip is ... more

Area thermal expansion coefficient

Thermal expansion is the tendency of matter to change in length, area or volume in response to a change in temperature, through heat transfer.
The ... more

Reduced pressure

In thermodynamics, the reduced properties of a fluid are a set of state variables normalized by the fluid’s state properties at its critical point. ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq5)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

...can't find what you're looking for?

Create a new formula