'

Search results

Found 573 matches
Allowable Strength Design Load combination (eq4)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Time Constant in RC electrical circuits

In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more

Time Constant in RL electrical circuits

In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more

Tractive Force

As used in mechanical engineering, the term tractive force can either refer to the total traction a vehicle exerts on a surface, or the amount of the total ... more

Intendation area for Vickers hardness test

The basic principle of the Vickers hardness test, as with all common measures of hardness, is to observe the questioned material’s ability to resist ... more

Ratiometric Correction of Transducer Output ( output voltage )

Piezoresistive transducers configured as Wheatstone bridges. often exhibit ratiometric behavior with respect not only to the measured pressure, but also ... more

NPN bipolar transistor ( Early Effect)

A bipolar junction transistor (BJT or bipolar transistor) is a type of transistor that relies on the contact of two types of ... more

Vertical Wind Profile - Power Law

The design of buildings must account for wind loads, and these are affected by wind shear. For engineering purposes, a power law wind speed profile may be ... more

Tractive Force - Steam locomotives

As used in mechanical engineering, the term tractive force can either refer to the total traction a vehicle exerts on a surface, or the amount of the total ... more

Output Voltage (voltage divider)

A voltage divider (potential divider) is a linear circuit that produces an output voltage that is a fraction of its input voltage. Voltage division refers ... more

...can't find what you're looking for?

Create a new formula