Search results
This formula calculates the geometrical requirements for pin ended members, specifically the minimum required distances from the pin hole edge to the plate ... more
A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A crank is an arm attached at right angles to a rotating shaft by which reciprocating motion is imparted to or received from the shaft. It is used to ... more
A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more
Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more
Safe Working Load (SWL) sometimes stated as the Normal Working Load (NWL) is the maximum safe force ... more
In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more
...can't find what you're looking for?
Create a new formula