'

Search results

Found 1799 matches
Mean Orbital Speed

The orbital speed of a body, generally a planet, a natural satellite, an artificial satellite, or a multiple star, is the speed at which it orbits around ... more

Apsis - Periapsis maximum speed

An apsis, plural apsidesis a point of greatest or least distance of a body in an elliptic orbit about a larger body. For a body orbiting the Sun the ... more

Apsis - Apoapsis minimum speed

An apsis, plural apsidesis a point of greatest or least distance of a body in an elliptic orbit about a larger body. For a body orbiting the Sun the ... more

Longitudinal waves velocity (compressional waves)

Longitudinal waves, are waves in which the displacement of the medium is in the same direction as, or the opposite direction to, the direction of travel of ... more

Worksheet 306

Calculate the force the biceps muscle must exert to hold the forearm and its load as shown in the figure below, and compare this force with the weight of the forearm plus its load. You may take the data in the figure to be accurate to three significant figures.


(a) The figure shows the forearm of a person holding a book. The biceps exert a force FB to support the weight of the forearm and the book. The triceps are assumed to be relaxed. (b) Here, you can view an approximately equivalent mechanical system with the pivot at the elbow joint

Strategy

There are four forces acting on the forearm and its load (the system of interest). The magnitude of the force of the biceps is FB, that of the elbow joint is FE, that of the weights of the forearm is wa , and its load is wb. Two of these are unknown FB, so that the first condition for equilibrium cannot by itself yield FB . But if we use the second condition and choose the pivot to be at the elbow, then the torque due to FE is zero, and the only unknown becomes FB .

Solution

The torques created by the weights are clockwise relative to the pivot, while the torque created by the biceps is counterclockwise; thus, the second condition for equilibrium (net τ = 0) becomes

Force (Newton's second law)
Torque
Force (Newton's second law)
Torque

Note that sin θ = 1 for all forces, since θ = 90º for all forces. This equation can easily be solved for FB in terms of known quantities,yielding. Entering the known values gives

Mechanical equilibrium - 3=3 Torque example

which yields

Torque
Addition

Now, the combined weight of the arm and its load is known, so that the ratio of the force exerted by the biceps to the total weight is

Division

Discussion

This means that the biceps muscle is exerting a force 7.38 times the weight supported.

Reference : OpenStax College,College Physics. OpenStax College. 21 June 2012.
http://openstaxcollege.org/textbooks/college-physics
Creative Commons License : http://creativecommons.org/licenses/by/3.0/

Variance

The variance is a parameter that describes, in part, either the actual probability distribution of an observed population of numbers, or the theoretical ... more

Bragg's Law - Lattice Spacing in Cubic Systems

In physics, Bragg’s law, or Wulff–Bragg’s condition, a special case of Laue diffraction, gives the angles for coherent and incoherent ... more

Freefall in Uniform Gravitational Field with Air Resistance (velocity)

Free fall is any motion of a body where its weight is the only force acting upon it. In Uniform gravitational field with air resistance the air resistance ... more

Critical Speed of a Rotating Shaft - Dunkerley's method

In solid mechanics, in the field of rotordynamics, the critical speed is the theoretical angular velocity that excites the natural frequency of a rotating ... more

Fractional bandwidth (RLC circuits)

The bandwidth as a fraction of the resonance frequency. Bandwidth is the difference between the upper and lower frequencies in a continuous set of ... more

...can't find what you're looking for?

Create a new formula