'

Search results

Found 888 matches
Factor of safety

Factor of safety (FoS) or (FS), is a term describing the structural capacity of a system beyond the expected loads or actual loads. Essentially, how much ... more

Margin of safety (measure of requirement verification)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

Micro chevron (MC) test (critical energy release rate)

The wafer bond characterization is based on different methods and tests. Wafer bonds are commonly characterized by three important encapsulation ... more

Margin of safety for failure load (measure of requirement verification)

Many agencies and organizations (such as aerospace) define the margin of safety (MoS or M.S.) including the design factor, in other words, the margin of ... more

Blade root bending moment load due to yaw

The blade root bending moment due to the wind turbine yaw operation. The yaw rate can be calculated for passive yaw, or is defined by the design for active ... more

Rankine Gordon formula (Maximum axial load that a column will buckle)

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Shaft bending moment due to yaw (2-bladed rotor)

The shaft bending moment due to yaw depends on the blades of the rotor. In this case the rotor has 2 blades

... more

Working Load Limit

Safe Working Load (SWL) sometimes stated as the Normal Working Load (NWL) is the maximum safe force ... more

Reserve factor as function of the ultimate strength and load

A measure of strength frequently used in Europe is the Reserve Factor (RF). With the strength and applied loads expressed in the same units, the Reserve ... more

Reserve factor

A measure of strength frequently used in Europe is the Reserve Factor (RF). With the strength and applied loads expressed in the same units, the Reserve ... more

...can't find what you're looking for?

Create a new formula