'

Search results

Found 1151 matches
Elastic deflection at any point along the span of a uniformly loaded cantilevered beam

In engineering, deflection is the degree to which a structural element is displaced under a load. The deflection at any point along the span of a uniformly ... more

Margin of safety for failure load (measure of requirement verification)

Many agencies and organizations (such as aerospace) define the margin of safety (MoS or M.S.) including the design factor, in other words, the margin of ... more

Total constant power (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

Maximum value of bending moments for a cantilever beam with uniformly distributed load

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Rule of Mixtures

In materials science, a general rule of mixtures is a weighted mean used to predict various properties of a composite material made up of continuous and ... more

Inverse Rule of Mixtures

In materials science, a general rule of mixtures is a weighted mean used to predict various properties of a composite material made up of continuous and ... more

Indent depth for Vickers hardness test

The basic principle of the Vickers hardness test, as with all common measures of hardness, is to observe the questioned material’s ability to resist ... more

Block and tackle - effort required to raise a given weight

A block and tackle is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift or pull heavy loads.The formula used ... more

Angle of deflection of a uniformly loaded cantilever beam

In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of ... more

Maximum deflection distance of an off-center loaded beam supported by two simple supports

In engineering, deflection is the degree to which a structural element is displaced under a load.
This maximum deflection occurs at a distance x_1 ... more

...can't find what you're looking for?

Create a new formula