'

Search results

Found 1351 matches
Specified Minimum Yield Strength (SMYS)

Specified Minimum Yield Strength (SMYS) means the specified minimum yield strength for steel pipe manufactured in accordance with ... more

Maximum value of bending moments for a cantilever beam with uniformly distributed load

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Self-buckling critical height ( for a free-standing, vertical column)

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Maximum value of bending moments for a center loaded beam supported by two simple supports

A bending moment is the reaction induced in a structural element when an external force or moment is applied to the element causing the element to bend. ... more

Brushed DC electric motor - Speed

A brushed DC motor is an internally commutated electric motor designed to be run from a direct current power source. Brushed motors were the first ... more

Ball Screw - Tensile Compressive Load

A ball screw is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical ... more

Transistor regulator ( Rv providing a bias current)

In the simplest case a common collector transistor (emitter follower) is used with the base of the regulating transistor connected directly to the voltage ... more

Maximum value of bending moments for a cantilever beam with end load

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Maximum elastic deflection of an off-center loaded beam supported by two simple supports

In engineering, deflection is the degree to which a structural element is displaced under a load.
The maximum elastic deflection on a beam supported ... more

Petroff's Law - Torque required to shear the lubricant film

In the design of fluid bearings, the Sommerfeld number (S), or bearing characteristic number, is a dimensionless quantity used extensively in hydrodynamic ... more

...can't find what you're looking for?

Create a new formula