'

Search results

Found 1527 matches
Shape Factor (Boundary-layer thickness)

A shape factor is used in boundary layer flow to determine the nature of the flow.
The higher the value of H, the stronger the adverse pressure ... more

Damping ratio (related to Quality factor)

Formula first contributed by:
trooper

In engineering, the damping ratio is a dimensionless measure describing how ... more

Tractive Force

As used in mechanical engineering, the term tractive force can either refer to the total traction a vehicle exerts on a surface, or the amount of the total ... more

Petroff's Law - Bearing coefficient of friction

In the design of fluid bearings, the Sommerfeld number (S), or bearing characteristic number, is a dimensionless quantity used extensively in hydrodynamic ... more

Maximum Velocity in Friction Banked Turn

A banked turn (aka. banking turn) is a turn or change of direction in which the vehicle banks or inclines, usually towards the inside of the turn. For a ... more

Permeability (porous material)

Permeability is a measure of the ability of a porous material a rock or unconsolidated material, to allow fluids to pass through it.
Permeability is ... more

Settling velocity

The terminal velocity of a particle which is falling in the viscous fluid under its own weight due to gravity.
Generally, for small particles (laminar ... more

Hagen-Poiseuille Equation

In fluid dynamics, the Hagen–Poiseuille equation, also known as the Hagen–Poiseuille law, Poiseuille law or Poiseuille equation, is a physical law that ... more

Petroff's Law - Torque required to shear the lubricant film (for small radial loads)

In the design of fluid bearings, the Sommerfeld number (S), or bearing characteristic number, is a dimensionless quantity used extensively in hydrodynamic ... more

Heat transfer coefficient of pipe wall (using inner/outer diameter)

Heat transfer describes the exchange of thermal energy, between physical systems depending on the temperature and pressure, by dissipating heat. The heat ... more

...can't find what you're looking for?

Create a new formula