'

Search results

Found 565 matches
Vertical Curve - Offset

Offsets are vertical distances from the initial tangent to the curve, play a significant role in vertical curve design.

Vertical Curves are the ... more

Crest curve length when S>L (Vertical curves for highway design)

Crest vertical curves are curves which, when viewed from the side, are convex upwards. This includes vertical curves at hill crests, but it also includes ... more

Crest curve length when S<L (Vertical curves for highway design)

Crest vertical curves are curves which, when viewed from the side, are convex upwards. This includes vertical curves at hill crests, but it also includes ... more

Glide Ratio

Gliding flight is heavier-than-air flight without the use of thrust; the term volplaning also refers to this mode of flight in animals. It is employed by ... more

Fresnel reflection (Reflectivity Rs)

The Fresnel equations (or Fresnel conditions) describe the behaviour of light when moving between media of differing refractive indices. The reflection of ... more

Fresnel reflection (Reflectivity Rp)

The Fresnel equations (or Fresnel conditions) describe the behaviour of light when moving between media of differing refractive indices. The reflection of ... more

Impulse (Velocity)

Impulse is the product of a force and the time, for which it acts. The impulse of a force acting for a given time interval is equal to the change in linear ... more

Net Thrust of a Rocket Engine

A rocket engine, or simply “rocket”, is a jet engine that uses only stored propellant mass for forming its high speed propulsive jet. Rocket ... more

Supersonic/Hypersonic Lift-to-Drag Ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Semi-Elliptic Laminated Leaf Spring (Stiffness)

Leaf spring, commonly used for the suspension in wheeled vehicles. The term is also used to refer to a bundled set of leaf springs. As the spring flexes, ... more

...can't find what you're looking for?

Create a new formula