Search results

Found 729 matches
Moment of inertia of a thick-walled cylindrical tube ( Axis at the center of the cylinder perpendicular to its height)

Moment of inertia is the mass property of a rigid body that defines the torque needed for a desired angular acceleration about an axis of rotation. Moment ... more

Minimum

Gives the minimum value in a set of numbers. The minimum of a set (as defined in set theory) is the least element in the set. Unbounded infinite sets ... more

Properties of concrete - modulus of elasticity

Concrete has relatively high compressive strength, but significantly lower tensile strength. As a result, without compensating, concrete would almost ... more

Tensile force for non-undercut threaded rod

A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq6b)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq6a)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Compression ratio

The compression ratio of an internal-combustion engine or external combustion engine is a value that represents the ratio of the volume of its combustion ... more

Allowable Strength Design Load combination (eq3)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Pitch diameter - in imperial units (gears)

A gear or cogwheel is a rotating machine part having cut teeth, or cogs, which mesh with another toothed part to transmit torque, in most cases with teeth ... more

Pitch diameter - in metric units (gears)

Is a predefined diametral position on the gear, where the circular tooth thickness, pressure angle and helix angles are defined. The standard pitch ... more

...can't find what you're looking for?

Create a new formula