'

Search results

Found 330 matches
Load and Resistance Factor Design (LRFD) - Load combinations (eq6b)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Process Capability Index - Cpkm

In process improvement efforts, the process capability index or process capability ratio is a statistical measure of process capability: the ability of a ... more

Process Capability Index - Cpm

In process improvement efforts, the process capability index or process capability ratio is a statistical measure of process capability: the ability of a ... more

Impact Pressure - isentropic flow

In compressible fluid dynamics, impact pressure (dynamic pressure) is the difference between total pressure (also known as pitot pressure or stagnation ... more

Impact Pressure - isentropic flow (ratio of specific heats =1.4)

In compressible fluid dynamics, impact pressure (dynamic pressure) is the difference between total pressure (also known as pitot pressure or stagnation ... more

Wave shoaling height

In fluid dynamics, wave shoaling is the effect by which surface waves entering shallower water change in wave height. It is caused by the fact that the ... more

NTU method - effectiveness (epsilon)

The Number of Transfer Units (NTU) Method is used to calculate the rate of heat transfer in heat exchangers (especially counter ... more

NTU method - actual heat transfer rate (q) (relative to the hot fluid)

The Number of Transfer Units (NTU) Method is used to calculate the rate of heat transfer in heat exchangers (especially counter ... more

NTU method - actual heat transfer rate (q) (relative to the cold fluid)

The Number of Transfer Units (NTU) Method is used to calculate the rate of heat transfer in heat exchangers (especially counter ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq4)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

...can't find what you're looking for?

Create a new formula