'

Search results

Found 1530 matches
Force between two nearby magnetized surfaces (relative to flux density)

The Gilbert model assumes that the magnetic forces between magnets are due to magnetic charges near the poles. This model produces good approximations that ... more

Power AC (3-phases)

Three phases AC power produced from three sinusoidal voltages which are generated out of phase with each other

... more

Richardson's law

Thermionic emission is the thermally induced flow of charge carriers from a surface or over a potential-energy barrier. This occurs because the thermal ... more

Current gain - simplified formula (for equal impedances)

The current gain can be calculated using current instead of power using Joule’s first law to calculate. In many cases, the input and output ... more

Inductors in Parallel

Components of an electrical circuit or electronic circuit can be connected in many different ways. The two simplest of these are called series and parallel ... more

Solar luminosity

is a unit of radiant flux (power emitted in the form of photons) conventionally used by astronomers to measure the luminosity of stars. It is defined in ... more

Horizontal Curve - Allowable radius

The allowable radius for a horizontal curve can then be determined by knowing the intended design velocity, the coefficient of friction, and the allowed ... more

Wave shoaling height

In fluid dynamics, wave shoaling is the effect by which surface waves entering shallower water change in wave height. It is caused by the fact that the ... more

Leadscrew efficiency

A leadscrew (or lead screw), also known as a power screw or translation screw, is a screw used as a linkage in a machine, to translate turning motion into ... more

Force between two bar magnets

The Gilbert model assumes that the magnetic forces between magnets are due to magnetic charges near the poles. This model produces good approximations that ... more

...can't find what you're looking for?

Create a new formula