Search results

The combined gas law is a gas law which combines Charles’s law, Boyle’s law, and Gay-Lussac’s law. The combined gas law states that:
... more

Avogadro’s law is an experimental gas law relating volume of a gas to the amount of substance of gas present. Avogadro’s law states that, ... more

Boyle’s law is an experimental gas law which describes how the pressure of a gas tends to decrease as the volume of a gas increases. The absolute ... more

The pressure of a gas of fixed mass and fixed volume is directly proportional to the gas’ absolute temperature. If a gas’s temperature ... more

The ideal gas law is the equation of state of a hypothetical ideal gas. It is a good approximation to the behaviour of many gases under many conditions, ... more

Operation of a solar cell can be understood from the equivalent circuit at right. Light, of sufficient energy (greater than the bandgap of the material), ... more

The ideal gas law is the equation of state of a hypothetical ideal gas. It is a good approximation to the behaviour of many gases under many conditions, ... more

Calibrated airspeed (CAS) is indicated airspeed corrected for instrument and position error.

When flying at sea level ... more

Calibrated airspeed (CAS) is indicated airspeed corrected for instrument and position error.

When flying at sea level ... more

The formula provides a way to determine the volume-based concentration of any individual gaseous component.

Dalton’s law is not strictly ... more

There exist simple fluid-specific correlations for heat transfer coefficient in boiling. The Thom correlation is for the flow of boiling water (subcooled ... more

Indicated airspeed (IAS) is the airspeed read directly from the airspeed indicator (ASI) on an ... more

Solar cell efficiency is the ratio of the electrical output of a solar cell to the incident energy in the form of sunlight. The energy conversion ... more

Solar cell efficiency is the ratio of the electrical output of a solar cell to the incident energy in the form of sunlight. The energy conversion ... more

An isochoric process, also called a constant-volume process, an isovolumetric process, or an isometric process, is a thermodynamic process during which the ... more

Wind-chill or windchill, (popularly wind chill factor) is the perceived decrease in air temperature felt by the body on exposed skin due to the flow of ... more

Wind-chill or windchill, (popularly wind chill factor) is the perceived decrease in air temperature felt by the body on exposed skin due to the flow of ... more

Calibrated airspeed (CAS) is indicated airspeed corrected for instrument and position error.

When flying at sea level ... more

Solar cell efficiency is the ratio of the electrical output of a solar cell to the incident energy in the form of sunlight. The energy conversion ... more

In materials science, fatigue is the weakening of a material caused by repeatedly applied loads. Fatigue strength is a measure of the strength of a ... more

An isothermal process is a change of a system, in which the temperature remains constant: ΔT = 0. This typically occurs when a system is in contact with an ... more

As used in mechanical engineering, the term tractive force can either refer to the total traction a vehicle exerts on a surface, or the amount of the total ... more

In heat transfer at a boundary (surface) within a fluid, the Nusselt number (Nu) is the ratio of convective to conductive heat transfer across (normal to) ... more

In fluid mechanics, Mach number (M or Ma) is a dimensionless quantity representing the ratio of speed of an object moving through a fluid and the local ... more

The von Mises yield criterion suggests that the yielding of materials begins when the second deviatoric stress invariant reaches a critical value. The von ... more

In probability theory, the normal (or Gaussian) distribution is a very commonly occurring continuous probability distribution—a function that tells the ... more

The Tetens equation is an equation to calculate the saturation vapour pressure of water over liquid and ice. It is named after its creator, O. Tetens who ... more

In fluid flow, friction loss (or skin friction) is the loss of pressure or “head” that occurs in pipe or duct flow due to the effect of the fluid’s ... more

Hydraulic conductivity is a property of vascular plants, soils and rocks, that describes the ease with which a fluid (usually water) can move through pore ... more

Pressure altitude within the atmosphere is the altitude in the International Standard Atmosphere with the same pressure as the part of the atmosphere in ... more