'

Search results

Found 943 matches
Voltage gain

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input ... more

Miller's Rule

In optics, Miller’s rule is an empirical rule which gives an estimate of the order of magnitude of the nonlinear coefficient.

More formally, ... more

Diagonal Resolution - Pixels

Pixels per inch (PPI) (or pixels per centimeter (PPCM)) is a measurement of the pixel density ... more

Relation between Polarization density and Electric field in various materials

In classical electromagnetism, polarization density is the vector field that expresses the density of permanent or induced electric dipole moments in a ... more

Relation between permeability and magnetic susceptibility

Permeability is the measure of the ability of a material to support the formation of a magnetic field within itself. In other words, it is the degree of ... more

Pixels Per Inch (PPI)

Pixels per inch (PPI) (or pixels per centimeter (PPCM)) is a measurement of the pixel density ... more

Damping factor (RLC circuit)

Damping is an influence within or upon an oscillatory system that has the effect of reducing, restricting or preventing its oscillations.( The neper ... more

Cutoff Frequency in Electronic Low-Pass Filters

A low-pass filter is a filter that passes signals with a frequency lower than a certain cutoff frequency and attenuates signals with frequencies higher ... more

Electrical Mobility in gas phase

Electrical mobility is the ability of charged particles (such as electrons or protons) to move through a medium in response to an electric field that is ... more

Wind Chill - original model

Wind-chill or windchill, (popularly wind chill factor) is the perceived decrease in air temperature felt by the body on exposed skin due to the flow of ... more

...can't find what you're looking for?

Create a new formula