'

Search results

Found 1532 matches
Maximum Pressure on a Contact Area between two cylinders with parallel axes

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more

Darcy friction factor - Colebrook–White equation (relative to the radius)

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Miles Equation

In 1954, Miles developed his version of this equation for GRMS as he was researching fatigue failure of aircraft structural ... more

Wind Power - Betz's law

Wind power is the conversion of wind energy into a useful form of energy, such as using wind turbines to produce electrical power, windmills for mechanical ... more

Gravity gradiant

Gravity gradiometry is the study and measurement of variations in the acceleration due to gravity. The gravity gradient is the spatial rate of change of ... more

Minimum railway curve radius (by the track gauge and the cant)

The minimum railway curve radius, the shortest allowable design radius for railway tracks under a particular set of conditions.
Track gauge is a ... more

Body Mass Index - BMI

The body mass index (BMI), or Quetelet index, is a heuristic proxy for human body fat based on an individual’s weight and ... more

Darcy friction factor - Blasius correlation

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Center of mass (for a system of n-particles)

The center of mass of a distribution of mass in space is the unique point where the weighted relative position of the distributed mass sums to zero.
... more

Danish-Kumar Solution (for Buckingham-Reiner equation)

A Bingham plastic is a viscoplastic material that behaves as a rigid body at low stresses but flows as a viscous fluid at high stress. It is named after ... more

...can't find what you're looking for?

Create a new formula