'

Search results

Found 1153 matches
Load and Resistance Factor Design (LRFD) - Load combinations (eq4)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Margin of safety for failure load (measure of requirement verification)

Many agencies and organizations (such as aerospace) define the margin of safety (MoS or M.S.) including the design factor, in other words, the margin of ... more

Van 't Hoff equation

The Van 't Hoff equation in chemical thermodynamics relates the change in the equilibrium constant, Keq, of a chemical equilibrium to the change in ... more

Matthews correlation coefficient

The Matthews correlation coefficient is used in machine learning as a measure of the quality of binary (two-class) classifications. It takes into account ... more

Lift-to-Drag Ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Block and tackle - effort required to raise a given weight

A block and tackle is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift or pull heavy loads.The formula used ... more

Standard Equation of an Ellipse

Ellipse is a curve on a plane surrounding two focal points such that a straight line drawn from one of the focal points to any point on the curve and then ... more

Current gain

In electronics, gain is a measure of the ability of a two-port circuit (often an amplifier) to increase the power or amplitude of a signal from the input ... more

Speeds and feeds - feed rate

The phrase speeds and feeds or feeds and speeds refers to two separate velocities in machine tool practice, cutting speed and feed rate. They are often ... more

Allowable Strength Design Load combination (eq5a)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

...can't find what you're looking for?

Create a new formula