'

Search results

Found 1353 matches
Stewart's Theorem ( for triangle's bisectors)

Stewart’s theorem yields a relation between the length of the sides of the triangle and the length of a cevian of the triangle. A cevian is any line ... more

Allowable Strength Design Load combination (eq2)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Barycenter (Two-body problem)

barycentre; from the Greek βαρύ-ς heavy + κέντρ-ον centre) is the center of mass of two or more bodies that are orbiting each other, or the point around ... more

Electrical Impedance

Electrical impedance is the measure of the opposition that a circuit presents to a current when a voltage is applied. The term complex impedance may be ... more

Antenna Gain - Relative to a Dipole

In electromagnetics, an antenna’s power gain or simply gain is a key performance figure which combines the antenna’s directivity and electrical ... more

Allowable Strength Design Load combination (eq3)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Wind turbine yaw error

All wind turbines operate with a yaw error. In this case an extreme yaw error of 30 degrees is assumed. The flapwise blade root bending moment due to that ... more

Distance between two points (three-space)

Distance is a numerical description of how far apart objects are. In analytic geometry, the distance between two points of the xyz-plane in three-space, ... more

Backlash (due to operating center modifications)

In mechanical engineering, backlash, sometimes called lash or play, is clearance or lost motion in a mechanism caused by gaps between the parts. It can be ... more

Backlash (due to tooth thickness changes)

In mechanical engineering, backlash, sometimes called lash or play, is clearance or lost motion in a mechanism caused by gaps between the parts. It can be ... more

...can't find what you're looking for?

Create a new formula