'

Search results

Found 1356 matches
Shaft bending moment due to yaw (2-bladed rotor)

The shaft bending moment due to yaw depends on the blades of the rotor. In this case the rotor has 2 blades

... more

Lensmaker's equation

A lens is a transmissive optical device which affects the focusing of a light beam through refraction. A simple lens consists of a single piece of ... more

Sagnac effect (phase difference)

The Sagnac effect, also called Sagnac interference, named after French physicist Georges Sagnac, is a phenomenon encountered in interferometry that is ... more

Blade root bending moment load due to yaw

The blade root bending moment due to the wind turbine yaw operation. The yaw rate can be calculated for passive yaw, or is defined by the design for active ... more

Shear coefficient (For solid rectangular cross-section beam)

Timoshenko beam model takes into account shear deformation and rotational inertia effects, making it suitable for describing the behavior of short sandwich ... more

Shear coefficient (For solid circular cross-section beam)

Timoshenko beam model takes into account shear deformation and rotational inertia effects, making it suitable for describing the behavior of short sandwich ... more

Auger electron spectroscopy - electron impact cross-section

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Lift-to-Drag Ratio - with wetted aspect ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Lift-to-Drag Ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Cross Section (flux)

The cross section is an effective area that quantifies the intrinsic likelihood of a scattering event when an incident beam strikes a target object, made ... more

...can't find what you're looking for?

Create a new formula