'

Search results

Found 937 matches
Tractive Force - Steam locomotives

As used in mechanical engineering, the term tractive force can either refer to the total traction a vehicle exerts on a surface, or the amount of the total ... more

Electrical Impedance

Electrical impedance is the measure of the opposition that a circuit presents to a current when a voltage is applied. The term complex impedance may be ... more

Ball Screw - Driving Torque

A ball screw is a mechanical linear actuator that translates rotational motion to linear motion with little friction. A threaded shaft provides a helical ... more

Rolling Resistance Coefficient - alternative

As an alternative to using Crr one can use b, which is a different rolling resistance coefficient or coefficient of rolling friction with dimension of ... more

Electrical resistivity (general definition)

Electrical resistivity (also known as resistivity, specific electrical resistance, or volume resistivity) is an intrinsic property that quantifies how ... more

Concrete electrical resistivity (rebars method)

Rebar (short for reinforcing bar), is a steel bar or mesh of steel wires used as a tension device in reinforced concrete and reinforced masonry structures ... more

Dynamic (shear) viscosity

The dynamic (shear) viscosity of a fluid expresses its resistance to shearing flows, where adjacent layers move parallel to each other with different ... more

Terminal velocity (potato-shaped obgject)

In fluid dynamics, drag (sometimes called air resistance, a type of friction, or fluid resistance, another type of friction or fluid friction) is a force ... more

Airway Conductance

In respiratory physiology, airway resistance is the resistance of the respiratory tract to airflow during inspiration and expiration. Airway resistance is ... more

Darcy's Law for membrane performance application

The selection of synthetic membranes for a targeted separation process is usually based on few requirements. Membranes have to provide enough mass transfer ... more

...can't find what you're looking for?

Create a new formula