'

Search results

Found 1650 matches
True Airspeed - High-speed flight

The true airspeed (TAS; also KTAS, for knots true airspeed) of an aircraft is the speed of the aircraft relative to the airmass ... more

Perfectly inelastic collision

A collision is an isolated event in which two or more moving bodies (colliding bodies) exert forces on each other for a relatively short time. Collision is ... more

Wet bulk density of soil (total bulk density)

Bulk density is a property of powders, granules, and other “divided” solids, especially used in reference to mineral components (soil, gravel), ... more

Vis-Viva Equation

In astrodynamics, the vis viva equation, also referred to as orbital energy conservation equation, is one of the fundamental equations that govern the ... more

Instantaneous current for L3 (Three-phase electric application)

In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more

Closed magnetic circuit (magnetic field)

An electromagnet is a type of magnet in which the magnetic field is produced by electric current. The magnetic field disappears when the current is turned ... more

Alfvén velocity

In plasma physics, an Alfvén wave, named after Hannes Alfvén, is a type of magnetohydrodynamic wave in which ions oscillate in response to a restoring ... more

Margin of safety for a failure load (measure of structural capacity)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

K2 for Danish-Kumar Solution

A Bingham plastic is a viscoplastic material that behaves as a rigid body at low stresses but flows as a viscous fluid at high stress. It is named after ... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

...can't find what you're looking for?

Create a new formula