'

Search results

Found 1428 matches
Triangle area

Triangle is a polygon with three edges and three vertices. The area of a triangle with base length b and height length h is given by multiplying base ... more

Allowable Strength Design Load combination (eq5a)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Allowable Strength Design Load combination (eq5b)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Damping ratio ( related to damping coefficients)

Linear damping occurs when a potentially oscillatory variable is damped by an influence that opposes changes in it, in direct proportion to the ... more

Shear stress (acting on the bed of a channel)

For a channel that is at an angle a from horizontal, the shear component of the stress acting on the bed , which is the component acting ... more

Shear rate at the inner wall of a Newtonian fluid (flowing within a pipe)

A Newtonian fluid is a fluid in which the viscous stresses arising from its flow, at every point, are proportional to the local strain rate — the rate of ... more

Channel bed pressure (at the bed of an open channel)

The depth–slope product is used to calculate the shear stress at the bed of an open channel containing fluid that is undergoing steady, uniform flow. The ... more

Redlich-Kwong (b - constant)

Introduced in 1949, the Redlich-Kwong equation of state was a considerable improvement over other equations of the time. It is still of interest primarily ... more

Net Profit Margin

Profit margin, net margin, net profit margin or net profit ratio all refer to a measure of profitability. It is calculated by finding the net profit as a ... more

Redlich-Kwong (a - constant)

Introduced in 1949, the Redlich-Kwong equation of state was a considerable improvement over other equations of the time. It is still of interest primarily ... more

...can't find what you're looking for?

Create a new formula