'

Search results

Found 1813 matches
Position of the piston of an engine with respect to crank angle

A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more

Velocity of the reciprocating motion of the piston with respect to crank angle

A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more

Acceleration of reciprocating piston with respect to crank angle

A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more

Piston stroke (displacement )

Almost all reciprocating engines use cranks (with connecting rods) to transform the back-and-forth motion of the pistons into rotary motion. The cranks are ... more

Rod and piston-to-stroke ratio

In a reciprocating piston engine, the connecting rod or conrod connects the piston to the crank or crankshaft. Together with the crank, they form a simple ... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

Knuckle joint (Moment about axis XX)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

Engine displacement

Engine displacement is the volume swept by all the pistons inside the cylinders of a reciprocating engine in a single movement from top dead centre (... more

Shear resistance of a pin

This formula calculates the shear resistance of a pin in a pin and plate connection.
From EN 1993-1-8 (2005) (English): Eurocode 3: Design of steel ... more

Geometrical requirements for pin ended members - Given thickness

This formula calculates the geometrical requirements for pin ended members, specifically the minimum required distances from the pin hole edge to the plate ... more

...can't find what you're looking for?

Create a new formula