'

Search results

Found 1642 matches
Auger electron spectroscopy - emitted electron kinetic energy

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Tier 1 capital

Tier 1 capital is the core measure of a bank’s financial strength from a regulator’s point of view. It is composed of core capital, which ... more

Shear stress (acting on the bed of a channel)

For a channel that is at an angle a from horizontal, the shear component of the stress acting on the bed , which is the component acting ... more

Bending moments at any point along the span of a cantilevered beam with the free end supported on a roller

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Mohr–Coulomb failure criterion

Mohr–Coulomb theory is a mathematical model describing the response of brittle materials such as concrete, or rubble piles, to shear stress as well as ... more

Boundary shear stress (for natural rivers)

Assuming a single, well-mixed, homogeneous fluid and a single acceleration due to gravity (both are good assumptions in natural rivers, and the second is a ... more

Bending moments at any point along the span of a uniformly loaded cantilevered beam

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Kinematic Viscosity

Viscosity is a property arising from collisions between neighboring particles in a fluid that are moving at different velocities. When the fluid is forced ... more

Strain

The Cauchy strain or engineering strain is expressed as the ratio of total deformation to the initial dimension of the material body in which the forces ... more

Geometrical requirements for pin ended members - Given thickness

This formula calculates the geometrical requirements for pin ended members, specifically the minimum required distances from the pin hole edge to the plate ... more

...can't find what you're looking for?

Create a new formula