'

Search results

Found 779 matches
Paper folding theorem (required width for alternate-direction folding)

Britney Crystal Gallivan (born 1985) of Pomona, California, is best known for determining the maximum number of times that paper or other materials can be ... more

Antiprism uniform ( surface area )

In geometry, an n-sided antiprism is a polyhedron composed of two parallel copies of some particular n-sided polygon, connected by an alternating band of ... more

Present value of a growing annuity

Present value of an annuity: An annuity is a series of equal payments or receipts that occur at evenly spaced intervals. Leases and rental payments are ... more

Lift-to-Drag Ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Cross Section (discrete events)

The cross section is an effective area that quantifies the intrinsic likelihood of a scattering event when an incident beam strikes a target object, made ... more

Paper folding theorem (required strip length for single-direction folding)

Britney Crystal Gallivan (born 1985) of Pomona, California, is best known for determining the maximum number of times that paper or other materials can be ... more

Alfvén velocity (in SI)

In plasma physics, an Alfvén wave, named after Hannes Alfvén, is a type of magnetohydrodynamic wave in which ions oscillate in response to a restoring ... more

Present value for Gradient payment

In economics, present value, also known as present discounted value, is a future amount of money that has been discounted to reflect its current value, as ... more

Darcy friction factor - Blasius correlation with correction for curved or helically coiled tubes

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Speeds and feeds - feed rate

The phrase speeds and feeds or feeds and speeds refers to two separate velocities in machine tool practice, cutting speed and feed rate. They are often ... more

...can't find what you're looking for?

Create a new formula