# Search results

Found 359 matches
Simplified von Mises equation - General - No restrictions

The von Mises yield criterion suggests that the yielding of materials begins when the second deviatoric stress invariant reaches a critical value. For ... more

Heat flow in electronics - maximum power dissipate

The heat flow can be modelled by analogy to an electrical circuit where heat flow is represented by current, temperatures are represented by voltages, heat ... more

Net Profit Margin

Profit margin, net margin, net profit margin or net profit ratio all refer to a measure of profitability. It is calculated by finding the net profit as a ... more

Net Profit Margin - with cost

Profit margin, net margin, net profit margin or net profit ratio all refer to a measure of profitability. It is calculated by finding the net profit as a ... more

Modulus of resilience

Resilience is the ability of a material to absorb energy when it is deformed elastically, and release that energy upon unloading. Proof resilience is ... more

Profit percentage

Profit percentage is the percentage of cost price that one gets as profit on top of cost price. Profit percentage is calculated with cost price taken as ... more

Frequency of a string under tension (nth harmonic)

A vibration in a string is a wave. Resonance causes a vibrating string to produce a sound with constant frequency, i.e. constant pitch. If the length or ... more

Auger electron spectroscopy - Total yield

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Tensile force for undercut threaded rod

A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the ... more

Concrete electrical resistivity (rebars method)

Rebar (short for reinforcing bar), is a steel bar or mesh of steel wires used as a tension device in reinforced concrete and reinforced masonry structures ... more

...can't find what you're looking for?

Create a new formula