'

Search results

Found 1295 matches
Bearing capacity - Terzaghi's Theory (Variable Nq)

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Angle of deflection of a uniformly loaded cantilever beam

In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of ... more

Torque of Compound pendulum

A compound pendulum (or physical pendulum) is one where the rod is not massless, and may have extended size; that is, an arbitrarily shaped rigid body ... more

Block and tackle - effort required to raise a given weight

A block and tackle is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift or pull heavy loads.The formula used ... more

Torque on a dipole (electric field)

A physical dipole consists of two equal and opposite point charges An electric dipole is a separation of positive and negative charges.The direction of an ... more

Lift-to-Drag Ratio - with wetted aspect ratio

In aerodynamics, the lift-to-drag ratio, or L/D ratio, is the amount of lift generated by a wing or vehicle, divided by the drag it creates by moving ... more

Indent depth for Vickers hardness test

The basic principle of the Vickers hardness test, as with all common measures of hardness, is to observe the questioned material’s ability to resist ... more

Leaning ( for bikes and motorcycles)

Bikes must lean during a turn to balance the relevant forces: gravitational, inertial, frictional, and ground support. The angle of lean can be ... more

Shaft work

Energy transmission with a rotating shaft is very common in engineering practice. Often the torque T applied to the shaft is constant which means that the ... more

Angle of deflection of an end loaded cantilever beam

In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of ... more

...can't find what you're looking for?

Create a new formula