'

Search results

Found 815 matches
Shape Factor (Boundary-layer thickness)

A shape factor is used in boundary layer flow to determine the nature of the flow.
The higher the value of H, the stronger the adverse pressure ... more

R-value (insulation) of a multi-layered installation - U.S. units

The R-value is a measure of thermal resistance, or ability of heat to transfer from hot to cold, through materials (such as insulation) and assemblies of ... more

Intendation area for Vickers hardness test

The basic principle of the Vickers hardness test, as with all common measures of hardness, is to observe the questioned material’s ability to resist ... more

Tier 2 capital

Tier 2 capital, or supplementary capital, include a number of important and legitimate constituents of a bank’s capital base. (Undisclosed Reserves ... more

Critical Buckling Stress of a Column with Buckling Coefficient

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Electrical Impedances - In Series

Electrical impedance is the measure of the opposition that a circuit presents to a current when a voltage is applied. The term complex impedance may be ... more

Electrical Impedances - In Parallel

Electrical impedance is the measure of the opposition that a circuit presents to a current when a voltage is applied. The term complex impedance may be ... more

Stiffness of an elastic body with a single degree of freedom

The stiffness of a body is a measure of the resistance offered by an elastic body to deformation. For an elastic body with a single degree of freedom (for ... more

Mean arterial pressure

The mean arterial pressure (MAP) is the average over a cardiac cycle and is determined from measurements of the systolic pressure ... more

Beamwidth - Parabolic Antenna

The beam diameter or beam width of an electromagnetic beam is the diameter along any specified line that is perpendicular to the beam axis and intersects ... more

...can't find what you're looking for?

Create a new formula