Search results

Found 1259 matches
Pumping power

The power imparted into a fluid increases the energy of the fluid per unit volume. Thus the power relationship is between the conversion of the mechanical ... more

Creep (deformation)

In materials science, creep (sometimes called cold flow) is the tendency of a solid material to move slowly or deform permanently under the influence of ... more

Properties of concrete - modulus of elasticity

Concrete has relatively high compressive strength, but significantly lower tensile strength. As a result, without compensating, concrete would almost ... more

Maszara model DCB test (The compliance of a symmetric DCB speciment)

Wafer bonds are commonly characterized by three important encapsulation parameters: bond strength, hermeticity of encapsulation and bonding induced stress. ... more

Maszara model DCB test (surface fracture energy)

Wafer bonds are commonly characterized by three important encapsulation parameters: bond strength, hermeticity of encapsulation and bonding induced ... more

Kinematic Viscosity

Viscosity is a property arising from collisions between neighboring particles in a fluid that are moving at different velocities. When the fluid is forced ... more

Bending moments at any point along the span of a uniformly loaded cantilevered beam

A cantilever is a beam anchored at only one end. The beam carries the load to the support where it is forced against by a moment and shear stress. A ... more

Simplified von Mises equation - Principal plane stress

RESTRICTIONS : σ₃ = 0, σ₁₂ = σ₁₃ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials begins ... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

Seiche - Longest natural period (Merian's formula)

A seiche (/ˈseɪʃ/ SAYSH) is a standing wave in an enclosed or partially enclosed body of water. Seiches and seiche-related ... more

...can't find what you're looking for?

Create a new formula