# Search results

Found 568 matches
Biot number (mass transfer)

The Biot number (Bi) is a dimensionless quantity used in heat transfer calculations. Gives a simple index of the ratio of the heat transfer resistances ... more

The blade root bending moment due to the wind turbine yaw operation. The yaw rate can be calculated for passive yaw, or is defined by the design for active ... more

Block and tackle - efficiency approximation - with friction factor

A block and tackle is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift or pull heavy loads.A more precise ... more

Block and tackle - efficiency approximation - without friction factor

f is the number of sheaves in the purchase, and there is a roughly % loss of efficiency at each sheave due to friction, then:

... more

Block and tackle - effort required to raise a given weight

A block and tackle is a system of two or more pulleys with a rope or cable threaded between them, usually used to lift or pull heavy loads.The formula used ... more

Boundary shear stress (for natural rivers)

Assuming a single, well-mixed, homogeneous fluid and a single acceleration due to gravity (both are good assumptions in natural rivers, and the second is a ... more

Bradley model of the force applied on a contact area between two spheres

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. When two solid surfaces are brought into close ... more

The clamping load is assumed to act on all friction surfaces equally. For dry disc brakes it doesnâ€™t matter whether the brake is of the sliding type or ... more

Brinell Hardness Number

BHN or Brinell Number is the numerical value assigned to the hardness of metals and alloys. The test is to determine the hardness ... more

Brinell scale ( using the SI units)

The Brinell scale characterizes the indentation hardness of materials through the scale of penetration of an indenter, loaded on a material test-piece. It ... more

...can't find what you're looking for?

Create a new formula